Dealer Signin Signin Signup

ALAT 10

Specification

According to the project and details,

  • Aypan TU profiles made of galvanized steel sheet according to TS EN 14195 should be fixed to the existing wall by using screws and plastic dowels at 60 cm intervals.
  • The first main bearing profile axis should be marked on the ceiling at a distance of 10 cm from the existing wall.
  • Consecutive axes should also be marked with a maximum distance of 60 cm.
  • Aypan shafts should be fixed with steel dowels on the lines marked with a maximum distance of 100 cm.
  • Shaft blades should be adjusted by bending to the distance of the suspended ceiling.
  • Aypan TC profiles should be cut.
  • TC profiles should be placed between two wings of the sheets.
  • Baffles should be fixed to baffles of TC profiles with baffle screws.
  • Joints should be used in the joints of TC profiles.
  • Aypan should be fixed to TU and TC profiles with 25 mm self-tapping screws.
  • If necessary, the plate should be cut and sized.
  • Pre-fill the gaps more than 3 mm with Aygips grouting plaster.
  • Screw heads should be covered with joint filler plaster.
  • The joint tape should be adhered to the plate joints.
  • Suspended ceiling should be formed by applying joint filler plaster on the joint tape.

The price is 1 m2 including all kinds of materials and losses, loading in the workplace, horizontal and vertical transport, unloading and contractor profit and general expenses.